Table of Contents
Advertisement
© Martin Engineering GmbH
2. Insert the holder arm (11, Fig.9) together with the threaded rod,
pivot joint blockand lower bearing bush with proper alignment
(Fig. 9) into the installation panel (1, Fig.9).
5
6
Fig. 10:
3. Insert the pivot joint block (6, Fig 10) and the upper bearing
bush (5, Fig 7).
Fig. 11:
4. Remove the hexagon head screw (16, Fig.11) on the clamp
(3, Fig. 11) and open the clamp.
5. Repeat steps 1 to 4 on the opposite side.
19
16
3
M3682UK-09/17
Advertisement
Table of Contents
