Advertisement
13. To install the cover:
a. Lay the abrasion cover (G) and assembled
heated hose (H) end to end. Refer to Fig. 8.
b. With the gun disconnected from the gun man-
ifold (J) and the air hose disconnected from the
gun, pull a couple of inches of the cover (G) over
the manifold and hoses and tape the cover to the
hoses.
c. Push the cover (G) onto the hoses. See Fig. 8.
The cover will double over itself and be turned
inside out as it slides over the hoses.
d. Secure the other end of the cover (G) with
tape.
8
307544
Installation
Fig. 8
14. Install hose abrasion cover before spraying. The
abrasion cover protects the heated hose from
damage caused by rough surfaces. It also mini-
mizes heat loss and protects the couplings from
damage. Order part no. 070411 and specify the
total length of your hose times 1.25.
J
G
H
04456
Advertisement
