Inspection And Unpacking - Blodgett KTT-G Series Installation Operation & Maintenance

CAUTION
SHIPPING STRAPS ARE UNDER TENSION
AND CAN SNAP BACK WHEN CUT. TAKE
CARE TO AVOID PERSONAL INJURY OR
DAMAGE TO THE UNIT BY STAPLES LEFT
IN THE WALLS OF THE CARTON.
CAUTION
THIS UNIT WEIGHS BETWEEN 214 AND
240 POUNDS (98 TO 109 Kg) DEPENDING
ON SIZE. INSTALLER SHOULD USE
PROPER EQUIPMENT TO LIFT SAFELY.
The kettles are shipped from
the factory strapped on a pallet.
Inspection & Unpacking
The unit arrives completely assembled, except for the tilting handle on hand tilt models
which is shipped inside the kettle. The unit is strapped on a skid and in a heavy carton.
Inspect the carton carefully for damage. Open the container and check the unit for
hidden damage. Report shipping damage or shipment errors to the delivery agent.
Write down the model number, serial number, and installation date for your unit at the
top of the Service Log on Page 33. Keep this manual with the unit.
To remove the kettle from the box, cut any straps from around the box. Detach the box
sides from the skid. Pull the box up off the unit, taking care to avoid damage or injury
from any staples left in the box walls. When installation is to begin, cut the straps holding
the kettle on the skid, and lift the kettle straight up off the skid. Examine the packing
materials to make sure no loose parts are discarded with the materials. On hand tilt
models, the tilting handle may be screwed into its socket. Attach handle to the kettle on
left side or right side as shown below.
OM-KTT/KTC-G 5