Remotemic - Phonak Virto B-Titanium Series Training Manual

Table of Contents

Advertisement

Pairing the RemoteMic
Before using the RemoteMic with a streamer for the first time, the
devices must first be paired with each other.
If you have received the RemoteMic and the streamer in a
set, they are paired already.
Put the streamer into pairing mode
With ComPilot Air II:
• Turn on and press the volume
up
button at the same time.
With ComPilot II:
• Turn on first. Press the connect
and volume up
buttons
at the same time for 2 sec.
The rapidly blinking blue
indicator light confirms that
the streamer is in pairing mode.
Understanding Indicator Light
Information during operation
Searching for paired device
Streaming
Pause mode
Pairing mode
82 Phonak VA DALC Training Guide
2.
audio

RemoteMic

Streamer
Solid green
Solid blue
Solid blue
Blink blue
Blink blue
Rapid blink blue
Rapid blink
blue
Put RemoteMic into pairing mode
If the RemoteMic has never been paired, it will automati-
cally be in pairing mode for 30 minutes after turning on.
This is indicated by a rapidly blinking blue indicator light.
To manually start pairing mode:
• Switch the RemoteMic off.
• Press and hold the volume up button (
• Turn the RemoteMic on while pushing
the (
) button at the same time.
1.
• Release the (
the indicator light starts rapidly
blinking blue.
• Make sure the streamer and RemoteMic
are within a 1 meter (3 ft) range.
The RemoteMic will remain in pairing mode for
2 minutes or until the pairing has been completed.
Completion of pairing
Wait until both indicator lights turn solid blue. This can take up
to 2 minutes but usually occurs within a few seconds.
You only have to pair the devices once. They will remain
paired and will automatically connect after being turned
on again.
RemoteMic power and battery information
power
Switching on
Switching off
Charging
Fully charged while charger
attached
Low battery warning
RemoteMic in sleep mode
or off
Switch the RemoteMic off and on again to turn the device
back on from sleep mode.
).
) button when
Green for 2 seconds
Red for 2 seconds
Solid red
Solid green
Additional red short blinks
Indicator light is not lit
at all
1.
2.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents