Table of Contents
Advertisement
"PIN" displays in the upper right corner of the
screen.
Note:
Rotate the key switch to the O
then to the O
position locks the protected menu.
N
You have the ability to view and change the settings in
the Protected Menu. Once you access the Protected
Menu, scroll down to Protect Settings option. Use the
right button to change the setting. Setting the Protect
Settings to O
allows you to view and change the
FF
settings in the Protected Menu without entering the
PIN code. Setting the Protect Settings to O
protected options and requires you to enter the PIN
code to change the setting in the Protected Menu.
After you set the PIN code, rotate the key switch O
and back to the O
position to enable and save this
N
feature.
To Set the Auto Idle
•
In the Settings Menu, scroll down to Auto Idle.
•
Press the right button to change the auto idle time
between OFF, 8S, 10S, 15S, 20S, & 30S.
Specifications
Note:
Specifications and design are subject to
change without notice.
Length
Width (Rear Wheels)
Height (with Roll Bar Up)
Height (with Roll Bar Down)
Weight
Attachments/Accessories
A selection of Toro approved attachments and
accessories is available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor or go to
www.Toro.com for a list of all approved attachments
and accessories.
position and
FF
hides the
N
FF
241.3 cm (95 inches)
147.3 cm (58 inches)
144.8 cm (78 inches)
137.2 cm (54 inches)
1152 kg (2540 lb)
18
Operation
Note:
Determine the left and right sides of the
machine from the normal operating position.
Checking the Engine-Oil
Level
Before you start the engine and use the machine,
check the oil level in the engine crankcase; refer to
Checking the Engine-Oil Level (page
Adding Fuel
Use only clean, fresh diesel fuel with ultra low (<15
ppm) sulfur content meeting ASTM D975 or EN590
specifications. The minimum cetane rating should be
40. Purchase fuel in quantities that can be used within
180 days to ensure fuel freshness.
Fuel tank capacity:51.1iters (13.5 US gallons)
Use summer grade diesel fuel (No. 2-D) at
temperatures above -7° C (20° F) and winter
grade (No. 1-D or No. 1-D/2-D blend) below that
temperature. Use of winter grade fuel at lower
temperatures provides lower flash point and cold flow
characteristics which will ease starting and reduce
fuel filter plugging.
Use of summer grade fuel above -7° C (20° F) will
contribute toward longer fuel pump life and increased
power compared to winter grade fuel.
Important:
Do not use kerosene or gasoline
instead of diesel fuel. Failure to observe this
caution will damage the engine.
WARNING
Fuel is harmful or fatal if swallowed.
Long-term exposure to vapors can cause
serious injury and illness.
• Avoid prolonged breathing of vapors.
• Keep face away from nozzle and fuel tank
or conditioner opening.
• Keep fuel away from eyes and skin.
Biodiesel Ready
This machine can also use a biodiesel blended fuel
of up to B7 (7% biodiesel, 93% petrodiesel). The
petrodiesel portion must be ultra low sulfur. Observe
the following precautions:
•
The biodiesel portion of the fuel must meet
specification ASTM D6751 or EN14214.
•
The blended fuel composition should meet ASTM
D975 or EN590.
45).
Advertisement
Table of Contents
