Setup; Adjusting The Rops; Checking The Tire Pressure - Toro Groundsmaster 360 31200 Series Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
Media and Additional Parts
Description
Operator's Manual
Engine Operator's Manual
Parts Catalog
Operator Training Material
1

Adjusting the ROPS

No Parts Required
Procedure
1. Remove the hairpin cotter pins and the pins from
the roll bar (Figure
2. Raise the roll bar to the upright position and
install the two pins and secure them with the
hairpin cotter pins
Note:
If you must lower the roll bar, push the bar
forward to relieve pressure on the pins, remove
the pins, lower the bar slowly, and secure it with
the pins so that it does not damage the hood.
Description
No parts required
No parts required
No parts required
3).
(Figure 3).
Qty.
–
–
–
Qty.
1 Read before operating the machine
1 Read before operating the machine
1 Use reference part numbers
1 View the video before operating the machine
1. Roll bar
2. Pin
12
Use
Adjust the ROPS
Check the tire pressure.
Check the hydraulic fluid, engine oil,
and coolant levels.
Use
Figure 3
3. Hairpin cotter pin
g014166