Table of Contents
Advertisement
Changing the Weight Adjustment
The seat can be adjusted to provide a smooth and
comfortable ride.
Important:
To adjust the seat for the drivers
weight the driver must be seated and the ignition
key moved to the On position.
The seat is adjusted for the driver's weight by pulling
or pressing the weight adjustment lever
The driver's weight is adjusted correctly when the
arrow is in the middle clear area of the viewing
window.
Within this viewing area, the seat can be adjusted to a
minimum spring movement.
When the minimum/maximum weight adjustment has
been reached, you can hear it reaching the upper or
lower end stop.
Important:
To prevent injury to the operator
and/or damage to the machine, the setting for the
driver's weight and the seat must be checked and
adjusted before the machine is operated.
Note:
To avoid compressor damage during weight
adjustment, the compressor must be operated no
longer than 1 minute.
Changing the Seat Position
The seat can move forward and backward. Position
the seat where you have the best control of the
machine and are most comfortable.
1.
To adjust, lift the lever to unlock the seat
40).
2.
Slide the seat to the desired position and release
lever to lock in position.
3.
Verify that the seat has locked into place by
attempting to move it back and forth.
Note:
Do not operate the locking lever while
operating the machine.
Changing the Lumbar Support
The lumbar support increases both the seating
comfort and the performance of the driver.
The back of the seat can be adjusted to provide a
customized lumbar support for your lower back.
By turning the adjustment knob upwards, the
curvature in the upper part of the backrest cushion
can be adjusted. By turning the knob downwards, the
curvature in the lower part of the backrest cushion can
be adjusted
(Figure
40).
0 = No curvature
1 = Maximum curvature at the top
2 = Maximum curvature at the bottom
Adjusting the Armrests
The armrests can be folded back if required and the
height individually adjusted.
(Figure
40).
To adjust the armrests for height, separate the round
cap
(Figure
nut (13 mm) behind it and adjust the armrests to the
desired position and tighten the nut. Replace the cap
onto the nut.
WARNING
Do not install the armrest in the lowest
position as the seat belt roller might not
function properly.
Changing the Armrest Angle
The angle of the armrests can be adjusted for operator
comfort.
To adjust the angle of the armrests, turn the
adjustment knob
When turning the knob to the outside (+) the front part
of the armrest will be lifted, when turning the knob to
inside (-) it will be lowered.
Changing the Backrest Position
(Figure
The back of the seat can be adjusted to provide a
more comfortable ride. Position the back of the seat
where it is most comfortable.
Pull up the locking lever to release the backrest catch
(Figure
not apply load to the backrest by pressing against it.
By exerting pressure on or off the front or rear of the
seat it can be moved to the desired position. Release
the locking lever to lock the backrest.
Note:
into another position after it has been locked.
35
40) from the cover, loosen the hexagon
(Figure
40).
40). When releasing the backrest catch, do
The backrest should not be able to move the
Advertisement
Table of Contents
