Table of Contents
Advertisement
•
Perform a recovery-regeneration whenever
there is a loss of engine power and a parked
regeneration cannot effectively clean the DPF of
soot.
•
A recovery regeneration requires up to 4 hours
to complete.
•
You need a distributor technician to perform the
recovery regeneration process; contact your
Authorized Toro Distributor.
Steering Selection
For maximum trimming and minimum turf damage
the machine should always be operated in 4 wheel
steering. However, when it is desired to transport
the machine on roads or trails, the machine can be
switched into 2 wheel steering.
1. Steering selector switch
Switching from 4 wheel steering to
2 wheel steering
Press the steering selector switch
forward position. If the wheels are not aligned in
the forward position, the green light will flash and
the machine will remain in 4 wheel steering until the
four tires are directed straight ahead. The operator
should turn the steering wheel slowly to straighten out
the wheels until the green light ceases to flash and
remains ON. When the switch light is solid green, the
machine is in 2 wheel steering.
Note:
If the steering wheel is turned too briskly,
steering misalignment may occur.
Switching from 2 wheel steering to
4 wheel steering
Press the steering selector switch
rearward position. If the front wheels are not aligned
in the forward position, the green light will flash and
the machine will remain in 2 wheel steering until the
Figure 35
(Figure
35) to the
(Figure
35) to the
four tires are directed straight ahead. The operator
should turn the steering wheel slowly to straighten
out the wheels until the green light ceases to flash
and remains OFF. If the steering wheel is turned too
briskly, steering misalignment may occur. When the
switch light is continuously OFF, the machine is in 4
wheel steering.
Note:
If the steering system is misaligned after
repeated 2 wheel steering to 4 wheel steering
engagements, refer to Correcting Steering
Misalignment in the Maintenance Section.
Stopping the Machine
To stop the machine, release the traction pedal to the
neutral position.
Set the parking brake whenever you leave the
machine. Remember to remove the key from the
ignition switch.
CAUTION
Children or bystanders may be injured if they
attempt to move or operate the tractor while
it is unattended.
Always remove the ignition key and set the
parking brake when leaving the machine
g026089
unattended, even if just for a few minutes.
Operating the Mower
Raising and Lowering the Mower
The deck lift switch raises and lowers the mower deck
(Figure
36). The engine must be running for you to
use this switch.
1. Deck lift switch
•
To lower the mower deck, push the switch forward.
•
To raise the mover deck, push the switch rearward.
32
Figure 36
g026088
Advertisement
Table of Contents
