Table of Contents
Advertisement
off and check fluid levels, check for oil
leaks, loose parts, and any other noticeable
malfunctions.
CAUTION
Shut the engine off and wait for all
moving parts to stop before checking
for oil leaks, loose parts, or other
malfunctions.
Stopping the Engine
1.
Disengage the PTO, make sure the traction
pedal is in the neutral position, set the parking
brake, and move the engine speed switch to the
idle position.
2.
Let the engine idle for 60 seconds.
3.
Turn the ignition key to the Off position. Wait
for all moving parts to stop before leaving the
operating position.
4.
Remove the key before transporting or storing
machine.
Important:
Make sure to remove the key as
the fuel pump or accessories may run and
cause the battery to lose charge.
CAUTION
Children or bystanders may be injured
if they move or attempt to operate the
tractor while it is unattended.
Always remove the ignition key and
set the parking brake when leaving the
machine unattended, even if just for a
few minutes.
Driving the Machine
The throttle control regulates the engine speed as
measured in rpm (revolutions per minute). Place
the throttle control in the Fast position for best
performance. Always operate in the Fast throttle
position when mowing.
Cutting Grass with the
Machine
Note:
Cutting grass at a rate that loads the engine
promotes DPF regeneration.
1.
Move the machine to the job site.
2.
Whenever possible, set the engine-speed switch
to high idle.
3.
Engage the PTO switch.
4.
Gradually move the traction pedal forward and
slowly drive the machine over the mowing area.
5.
Once the front of the cutting units are over the
mowing area, lower the cutting units.
6.
Cut grass so that the blades can cut and
discharge clippings at a high rate while
producing a good quality of cut.
Note:
If the cutting rate is too high, the quality
of cut may deteriorate. Reduce the ground
speed of the machine or reduce the width of cut
to regain high idle engine speed.
7.
When the cutting units are over the far edge of
the mowing area, lift the cutting units.
8.
Perform a tear-shaped turn to quickly line up for
your next pass.
23
Advertisement
Table of Contents
