Table of Contents
Advertisement
2
Checking the Tire Pressure
No Parts Required
Procedure
The tires are over inflated for shipping. Therefore,
release some of the air to reduce the pressure. The
correct air pressure for non-cab models is 103 kPa (15
psi) in the front tires and 172 kPa (25 psi) in the rear
tires. If a cab is installed on the machine, the front and
rear tires should be inflated to 172 kPa (25 psi).
3
Checking the Fluid Levels
No Parts Required
Procedure
1.
Check the hydraulic fluid level before starting
the engine, refer to Checking the Hydraulic Fluid
Level in the Maintenance Section.
2.
Check the engine oil level before starting the
engine, refer to Checking the Engine Oil Level in
the Maintenance Section.
3.
Check the cooling system before starting the
engine; refer to Checking the Cooling System in
the Maintenance Section.
Product Overview
Controls
Become familiar with all the controls before you start
the engine and operate the machine.
Traction Pedal
The traction pedal
(Figure
reverse operation. Press the top of the pedal to move
forward and the bottom to move rearward. Ground
speed depends on how far you press the pedal. For
no load, maximum ground speed, fully press the pedal
while the throttle is in the Fast position.
To stop, reduce foot pressure on the traction pedal
and allow it to return to the center position.
1. Parking brake
2. Brake pedal
3. Tilt steering pedal
Mow Speed Limiter
The mow speed limiter lever
forward to limit the traction speed while operating.
Brake Pedal
The brake pedal is used in conjunction with the brake
pedal latch to engage and disengage the parking
brake
(Figure
4) To stop the machine, release the
traction pedal and allow it to return to the center
position. The brake can assist in stopping in an
emergency situation.
13
4) controls the forward and
Figure 4
4. Traction pedal
5. Mow speed limiter
(Figure
4) can be flipped
g014168
Advertisement
Table of Contents
