Hydraulic Tank Installation - Tiger JD 5083E Mounting And Operating Instructions

HYDRAULIC TANK INSTALLATION

Attach the tank mount to the main frame with the hardware shown in the parts
section.
Install all fittings and tubes into tank and tank filter as shown in parts section
illustration. Insert tank sight glass into front side of the tank. Install the temperature
sensor (optional) or pipe plug into the side of the tank.
Place the tank in the mounting bracket on the main fame as shown in the parts
section. Secure the tank in the mounting bracket with the tank strap and nylock nuts.
Install the filter gauge into the filter housing so that it points to the rear of the
tractor and is clearly visible to the operator. The breather cap will be installed after
tank is filled.
GENERAL HOSE INSTALLATION
Refer to the parts section for detailed information about hoses and fittings for this
application.
When mounting the suction hose between the pump and the tank, the stainless
steel bands that are provided must be used. CAUTION: DO NOT use regular hose
clamps for this purpose.
For protection of hoses in contact with metal edges, wrap hoses with spit hose
sections and fasten with hose clamps or zip ties as needed.
SWIVEL BRACKET MOUNTING
Install the boom swivel bracket onto the boom mounting bracket with the swivel
pin. Secure the pin in place using the capscrews, etc. through the hole in the boss
and pin. NOTE: The head of the capscrew must be toward the front of the tractor.
Install all new swivels and fittings on the swing cylinder with swivel openings
facing each other. Fittings will vary in type and direction depending on your
application, refer to your parts section for more detail.
Install bushings (with split facing the direction of the grease zerk hole) in the main
frame anchor for the swing cylinder. This may already be done for you.
Install the swing cylinder between the main frame cylinder anchor and the boom
swivel bracket with the clevis pins. Insert roll pins through the top hole in the clevis
pins, and secure the bottom of the pins with the hairpin clips.
Now the hoses can be attached from the control valve to the swing cylinder
ASSEMBLY
Assembly Section 2-18