Trouble Shooting - Tiger JD 5083E Mounting And Operating Instructions

WEEKLY OR EVERY 50 HOURS
ITEM
In Tank Hyd. Fluid Filter
(10 micron filter)
In-Line High Pressure Filter
(10 micron filter)
Chain Coupling
MONTHLY OR EVERY 150 HOURS
Hydraulic Fluid Level
Hyd. Tank Breather
YEARLY OR EVERY 500 HOURS
Spindle Grease
Hyd. Tank Fluid
In Tank Hyd. Fluid Filter
(10 micron filter)
In-Line High Pressure Filter
(10 micron filter)
Hyd. Tank Breather
SYMPTOMS
Vibration
Mower will not lift
Mower will not start
or run
MAINTENANCE
SERVICE
Change
Change
Check
Check
Clean/Check/Replace
Change
Change
Change
Change or
Change

TROUBLE SHOOTING

CAUSE
1. Loose bolts
2. Cutter assembly
Unbalanced
1. Hyd. Fluid low
2. Leaks in line
3. Faulty relief valve 3. Check pressure in line. Line
4. Kinked or blocked 4. Clean or replace line.
5. Faulty cylinder
1. Blown fuse
2. Ball valves closed 2. Make sure valves are open
3. Low oil level
4. Line leak
Cheetah Maintenance Section 4-4
COMMENTS
Change after the first 50 hours only,
then every 500 hours, yearly or if
indicated by the restriction indicator.
Change after the first 50 hours only,
then every 500 hours, yearly or if
indicated by the restriction indicator.
Add as needed
Clean or replace element as required
Change when indicated by restriction
indicator.
1. Check all bolts and tighten to
torque specs. in this section
2a. Check for damaged blades, disc.
or cutter shaft. Replace if needed.
2b. Check for wire, rope, etc.
entangled in cutter assembly
1. Check and refill Hyd. Fluid
2. Tighten or replace fittings and hoses
pressure in Control Valve
should be at least 2500 P.S.I.
5. Inspect, repair or replace cylinder
1. Check fuse between mower switch
and ignition / replace
3. Check Hyd. tank and fill
4. Check all fittings and lines,
REMEDY