Regular Maintenance - Tiger JD 5083E Mounting And Operating Instructions

REGULAR MAINTENANCE

The intervals at which regular servicing should be done are based on hours of
operation. Use the tractors hour meter to determine when regular servicing is
required.
This symbol indicates a point that needs to be greased at an interval
noted in the section below. Refer to the Detailed Maintenance section
for further instructions on greasing. Copy and use the Daily
Maintenance sheet located at the end of this section.
ITEM
Pump Drive Shaft
Crankshaft Adapter
Pivot Points
Hydraulic Fittings
Knives
Knife mounting bolts
(knife to disk)
Disk mounting bolts
(disk to spindle)
Spindle mounting bolts
(Spindle to Deck)
Belts
Main Frame and
Deck
Hydraulic Fluid Level
Rear Flail Drive (if applicable)
Bearing Flange and
Shaft Coupler
Cutter Shaft and
Ground Roller
Ground Roller Bearings
Cutter Shaft Bearings (Flail)
MAINTENANCE
DAILY OR EVERY 8 HOURS
SERVICE
Check and Lube
Check rubber grommets Replace grommets if
Lubricate
Check for leaks
Check
Check
Check
Check
Check / Adjust
Check
Check
Lubricate
Lubricate
Lubricate
Lubricate
Cheetah Maintenance Section 4-3
COMMENTS
Insure drive shaft end
play
damaged or missing
Inject grease until it
appears at ends
Tighten when needed.
Do Not use hands to
check for leaks, see
maint. Precautions
Inspect for missing or
damaged knives, change
as needed
Re - torque to 800 ft. lbs.
Torque to 180 ft lb lubricated
Torque to 204 ft lb dry
Torque to 315 Ft lubricated
Torque to 357 Ft dry
Check if broken, tighten
as required
Retorque bolts to torque
specifications in this section
Add if required per
fluid recommendations
Grease as instructed in
detailed maint. section
Grease as instructed in
detailed maint. section
Grease as instructed in
detailed maint. section
Grease as instructed in
detailed maint. section