Tiger SIDE FLAIL ASEMBLIES JD 5065M Mounting And Operating Instructions page 42

FILLING HYDRAULIC RESERVOIR
Refer to the maintenance section for filling specifications and hydraulic oil requirements.
NOTE: Starting or running your Tiger mower before filling reservoir will cause
serious damage to hydraulic pump.
(ASM-C-0004hydro resrv)
WHEEL SPACER WITH WHEEL WELL TANK
When the left wheel is off, a spacer kit is needed with the wheel well tank (part# 06200637.)
Attach the spacer to the left wheel portion of the axle with the hardware provided. When you are
ready to re-attach the left wheel, the wheel goes on first then the reinforcement ring and finally
the hardware provided.
INSTALLING O-RING FITTINGS
Installing straight, 45º and 90º O-rings requires that the O-ring and washer be up against the
swivel body. Insert the swivel and turn in until the swivel is pointed in the desired direction and O-
ring contact is made. Hold swivel in set direction with a wrench and turn the O-ring nut away
from the swivel body and carefully tighten.
INSTALLING NATIONAL PIPE FITTINGS
Whenever installing a pipe fitting, wrap the threads clockwise (looking at the end) with
teflon tape. In this way, the tape will be tightened when installed. NOTE: It is not
necessary to tape O-ring fittings, or those installed in swivels.
GENERAL HOSE INSTALLATION
Refer to the parts section for detailed information about hoses and fittings for this
application.
(ASM-C-0011)
Secure hoses together with zip ties wherever loose. Wrap the hoses between the
swivel and main boom with the hose cover provided. Wrap the hoses between the main
boom and secondary boom with the hose cover provided. Where hoses may contact the
frame or other edges, wrap with split hose and secure with hose clamps or zip ties.
On non cab units, the pressure and return hoses from the control valve will also need
to be routed inside the protective clear hose wrap. Cover the valve, valve fittings with the
yellow hose cover and secure with black string provided.
Install a solenoid valve on the mounting bracket with the supplied hardware as shown
in the Parts Section in this manual. While installing the fittings to the brake valve, the
electical coil on the spool may have to be removed to make room. When reinstalling the
coil, it is important to use no more than 5 ft. lbs. (or 60in. lbs.) torque. WARNING: OVER
TORQUE TO THE COIL WILL RESULT IN HYDRAULIC FAILURE OF SPOOL.
ASSEMBLY
(ASM-JD-0070)
(ASM-C-0056)
HOSE COVERING
SOLENOID BRAKE VALVE
Assembly Section 2-16
(ASM-C-0088)
(ASM-C-0058)
(ASM-C-