TRAVEL LOCK MOUNTING
Install the travel lock bracket with pin and clip on the draft beam. Slide the draft beam
and align the travel lock bracket hole with the mounting hole on the main frame. Install the
capscrew, lockwasher and hex nut as shown in the picture.
Raise the deck/flail to it's upright position (Deck ear touches to stop bolt as shown in
the picture). Drill a 13/16" hole to the deck/flail ear through the draft beam as shown
below. Insert the supplied pin and clip through the hole.
ASSEMBLY
Assembly Section 2-25
(ASM-SIDE TRVL LOCK-0001)