Tractor Preparation - Tiger SIDE FLAIL ASEMBLIES JD 5065M Mounting And Operating Instructions

Before attempting to mount your Tiger mower, it is important
to read an understand all of the Safety Messages in the Safety
section of this manual.
Check complete shipment list against the packing list to make sure there are no
shortages. Make certain the tractor model is the appropriate one for the mower received!
Always use a floor jack, hoist or fork lift to lift and raise heavy parts.
Read and understand the entire assembly section instructions before attempting to mount
your Tiger mower. Refer to the parts section of this manual for detailed illustrations to locate all
parts.
(ASM-C-0001)
A. Remove right and left hand steps.
B. Disconnect battery cables from both batteries.
C. Remove engine side panels, or raise hood to access front pulley.
D. Remove plugs from tractor casting where main frame and pump mount will be attached.
E. Remove any front weights and weight supports.
F. Raise the tractor onto jack-stands and remove the right and left rear wheels.
(ASM-JD-0001)
For JD5065M and 5075M tractors, remove the four capscrews from the crankshaft pulley.
Then install the crankshaft adapter and spacer to the pulley with the capscrews and lockwashers
as shown in the Parts Section.
For JD5085M - JD5105M tractors, install the John Deere kit LVB24989 and follow the
instructions.
(ASM-JD-0085)
ASSEMBLY

TRACTOR PREPARATION

CRANKSHAFT ADAPTER
Assembly Section 2-2