Tiger SIDE FLAIL ASEMBLIES JD 5065M Mounting And Operating Instructions page 52

TRAVEL LOCK INSTALLATION
Your side flail bonnet(s) may have come without the travel lock hook welded
on. This is done after assembly to ensure a proper fit to your equipment. Follow
the following steps to attach the travel lock. Make sure to wear the proper
personal protection equipment.
1. Mout the left and/or right travel lock brackets loosely to each side of the mast
frame.
Refer to the Parts Section in this manual for part information.
2. Raise flail bonnets up totheir highest position.
3. Lower draft beam cylinders 1-1/2 inches for travel lock hook clearance.
4. Mount the hook to the travel lock bracket with travel lock pin in place.
5. Line up the travel lock plate so that it is centered with the travel lock hook on
each
side.
6. Weld the plates to the bonnets.
7. Weld the hooks to the plates.
ASSEMBLY
(ASM-T3F-0025)
Assembly Section 2-26