Battery Replacement - LaMotte Tracer 1741 Manual

Battery Replacement

1. Twist off the battery compartment cap.
2. Hold the battery housing in place with one finger. Remove the battery
carrier by pulling on the small tabs.
3. Replace the four CR2032 batteries. Observe polarity.
4. Replace the battery compartment cap.
NOTE: If the batteries are removed, stored data and user calibrations
will be cleared. A new user calibration will be required. Factory
calibrations will be retained.
All EU users are legally bound by the Battery Ordinance to
return all used batteries to community collection points or
wherever batteries/accumulators are sold.
Disposal in household trash or refuse is prohibited.
DISPOSAL: Follow the valid legal stipulations in respect of the disposal of the
device at the end of its life cycle
Other Battery Safety Reminders
¬ Never dispose of batteries in a fire. Batteries may explode or leak.
¬ Never mix battery types. Always install new batteries of the same type.
Cleaning and Conditioning the Electrode
Surface Cleaning – Only in case of visible surface contamination or if
readings should become erratic, use a disposable laboratory towel wetted
with ethanol or isopropyl alcohol and gently rub the surface, until no more
residue is visible.
11