Lubrication - Tiger RBF-14C Operator's Manual

LUBRICATION

Gearbox
The gearbox on the machine is filled with 10W/30 oil before it leaves the factory and should not need
topping-off, although it is recommended that the oil level is checked before the machine is used. Change
the oil after the first 200 hours of operation and thereafter every 1600 hours of operation.
Grease Points
All grease points shown in FIGURE 5-1 below should be greased before operating the machine. To make
greasing easier by relieving the weight form the pivot pins, rest the rotor unit on the ground, stop tractor
engine and operate control levers in both directions. Grease daily or every 8 hours of operation. Use a
high quality lithium base #2 grease.
PTO Drive Tubes
Grease PTO square tubes before operating machine. Grease the PTO bearings every 8 hours of operation
FIGURE 5-1
*NOTE:
Lubricate flail roller bearing until lubricant
can be seen coming out between
roller and bearing housing.
RBF-14C 07/04
© 2004 Alamo Group Inc.
MAINTENANCE
A. 1st Ram Pivots
B. Breakout Ram Pivot
C. P.T.O. Shaft
D. 1st Arm Pivot (Base)
E. 2nd Ram Pivots
F. 1st and 2nd Arm Pivot
G. 3rd Ram Pivots
H. Rotor Link / Ram Pivot
I. Rotor Link Pivot
L. Rotor Unit Pivot
M. Rotor Shaft Bearing
Total
Maintenance Section 5-2
2 Fittings
2 Fittings
2 Fittings
1 Fitting
2 Fittings
2 Fittings
2 Fittings
2 Fittings
1 Fitting
1 Fitting
1 Fittings
20 Fittings