Pen-Pc Communication Settings; Communication Settings; Desktop Modes - Turn Pen Communications Off/On - WizCom Technologies Quicktionary 2 Premium Professional Manual

Pen-PC Communication Settings

There are four ways in which the Pen communicates with the
PC via the Desktop application:
QuickLink (initiated by Pen)
Scan to PC (initiated by Pen)
Optimize Pen File System (initiated by Desktop)
Launching the Add\Remove Pen Components
dialog (initiated by the Desktop)
When communicating with the PC, the Pen must be
connected to the PC using the cable provided with the Pen.

Communication Settings

The Communications Settings dialog box (accessed from
the Pen-PC Communications menu on the Menu Bar)
allows the following information to be modified:
The type of communications (either Cable or Infra-
Red).
The communications port on the computer to which
the connection device is associated.
The communications baud rate (the speed at which
the data is transmitted), if you are using a cable.
The Infra-Red driver, if you are using Infra-Red
communications.
Communications settings must be defined correctly on both
the Pen and Desktop in order for the two to communicate.
See Establishing Pen-PC Communications on page 9 to
configure the correct communication settings for both the
Pen and PC.
Desktop Modes – Turn Pen
Communications Off/On
The Desktop application runs in two modes - online or
offline. The default mode is online.
Offline Mode
When the computer is offline, communications with the Pen
are disabled. The Desktop cannot detect communications
from, or initiate communications with the Pen. The Pen
Communications menu options are disabled.
The WizCom Desktop
63