Disassembling Of Right Cover Unit - Canon ZR70 MC A Service Manual

1-18 Disassembling of Right Cover Unit - 3

(1) Remove nine screws (d × 3, g × 4, j × 2) and the two soldered parts A and detach the R-Key P.C.B., DSW2 P.C.B., Holders 1 and
2, GND Plates 1 and 2 and Card Cover Lock.
<Note on Reassembling>
(1) Treat the DSW2 P.C.B. cable as illustrated below. Hook the top of the DSW2 P.C.B. to the Claw part B for mounting.
(2) Treat the R-Key P.C.B. flexible cable as illustrated below.
When using the part supplied for repair service, bend the flexible cable part A to 45°.
(3) Attach UL Tape at the position indicated in the figure shown below. (Only for ZR70 MC A)
Card Cover Lock
Note on Reassembling (1)
Claw B
Take care to prevent
the cable from hanging
over the boss part.
Holder 2
(1)
ZR70 MC A
ZR65 MC A
only
DSW2
GND Plate 2
P.C.B.
d g
4.5mm
Metal
Metal
M1.7
M1.7
(self tap)
Fig. 4-17
4-18
CHAPTER 4. DISASSEMBLING ADJUSTMENT
Note on Reassembling (3)
(ZR70 MC A only)
Attach UL Tape
according to the profile of the Connector.
(1)
(1) - g
Claw B
(1) - g
(1) - g
(1) - d
GND Plate 1
(1) - j
Note on Reassembling (2)
(1) - j
j
2mm
5.5mm
Metal
M1.7
(self tap)
ZR70 MC A, ZR65 MC A, ZR60 A
UL Tape
(5 × 10)
UL Tape (5 × 10)
R-KEY
P.C.B.
Soldered
Parts A
(1) - d
Holder 1
(1)
DSW2 P.C.B.
(1) - d
Plate 1 Flexible Cable
part A
Hold the flexible cable
part A with the plate.