Disassembling And Reassembling; Disassembling / Reassembling Flowchart - Canon ZR70 MC A Service Manual

1. Disassembling and Reassembling

Notes :
(1) When replacing the flat cable with a new one, allow it to remain folded the same as the original part.
(2) The flat cable has a contact orientation to be engaged with the connector. Refer to the instructions in the disassembly procedure
diagram and interconnection diagram for boards.
⋅ Lateral engaging connector
(The instructions are given in the disassembly procedure diagram and board interconnection diagram.)
: Contacts are positioned downward. (board side)
∗ : Contacts are positioned upward.
⋅ Lengthwise engaging connector
(The instructions are given only in the boards interconnection diagram.)
Indicated by →. Arrowheads indicate the contacts, and the shafts indicate the noncontacts.
(3) To secure screws, apply the Three Bond 1401B (CY9-8011-000)
(4) If any part to be replaced has UL tape attached on it, be sure to reattach UL tape at the same position in reassembling.

1-1 Disassembling / Reassembling Flowchart

(1) Find the replacement part on the chart, and disassemble it following the instruction on chart.
(2) Reassembling can be made by reversing the disassembling procedures.
START
1-2 Front Cover Unit
1-3 Accessory Shoe
1-4 Right Cover Unit
1-5 Rear Cover Unit
1-6 JACK P.C.B.
1-7 Left Cover Unit
1-8 Recorder, Camera Unit
1-11 Mic Ass'y
1-15 LCD Unit
1-16 CARD P.C.B.
1-17 R-KEY Back Light Ass'y
1-18 R-KEY P.C.B.
1-18 DSW2 P.C.B.
1-22 CVF Unit
1-23 DC P.C.B.
1-12 Operetion Key Ass'y
1-13 Speaker Ass'y
1-13 EJECT P.C.B.
1-14 Cassette Arm Ass'y
1-8 Recorder Unit
1-8 Camera Unit
4-1
ZR70 MC A, ZR65 MC A, ZR60 A
CHAPTER 4. DISASSEMBLING ADJUSTMENT
1-20 Hinge Ass'y
1-21 LCD P.C.B.
1-26 CVF P.C.B.
1-9 CAC P.C.B.
1-9 MAIN P.C.B.
1-10 Recorder Holder
1-10 DMC III
1-28 CCD P.C.B.
1-29 Lens Unit
: MAIN FLOW
: SUB FLOW
: MAIN UNIT