Disassembling Of Camera Unit - Canon ZR70 MC A Service Manual

1-27 Disassembling of Camera Unit - 1

(1) Remove one screw (k × 1) and detach the Accessory Shoe.
Note : Lift the hooked parts of the two Dowels diagonally and detach the Shoe Base backward.
(2) Remove three screws (l × 3) and detach the Lens Holder, vibration isolating Rubber and Shield.
<Note on Reassembling>
(1) When using the vibration isolating Rubber parts supplied for repair service, apply HANAL FL-778 (DY9-3026-000) to the entire
surface of each vibration isolating Rubber part.
(2) Attach Shield at the position indicated in the figure shown below.
(1) - k
Rubber
AAS FPC
(ZR70 MC A only)
Lens Holder
Rubber
(2) - l
Shoe Connector Ass'y
(ZR70 MC A)
Shoe Spacer
(ZR65 MC A, ZR60 A)
Shoe Base
(1)
(2)
(2) - l
Fig. 4-26
CHAPTER 4. DISASSEMBLING ADJUSTMENT
Caution
Lift Up
Note on Reassembling (2)
Shield
Attach the shield
so that the cutout
of the shield is aligned
with the hole on the
lens holder.
(Protrusion to the hole is not allowed.)
Shield
Rubber
Steped Screw
4-27
ZR70 MC A, ZR65 MC A, ZR60 A
Dowel
Dowel
Lens Holder
k l
4.5mm
3.8mm
Metal
Black
M1.7
M1.7
Steped Screw