Preparing For Installation; Safety Recommendations; Safety Symbols; General Safety Recommendations - H3C MSR830 Series Installation Manual

Preparing for installation

Figure 1 This document applies to the following device models:
Model
MSR830-6EI-GL
MSR830-6HI-GL
MSR830-10HI-GL
MSR830-10EI-GL

Safety recommendations

Safety symbols

When reading this document, note the following symbols:
WARNING means an alert that calls attention to important information that if not understood or
followed can result in personal injury.
CAUTION means an alert that calls attention to important information that if not understood or
followed can result in data loss, data corruption, or damage to hardware or software.

General safety recommendations

•
Keep the chassis and installation tools away from walk areas.
•
Make sure the ground is dry and flat and anti-slip measures are in place.
•
Unplug all the external cables (including power cords) before moving the chassis.

Electricity safety

•
Locate the emergency power-off switch in the room before installation. Shut the power off at
once in case accident occurs. Disconnect the power cord of the router if necessary.
•
Make sure the router is correctly grounded.
•
Do not open or close the chassis cover when the router is powered on.
•
Correctly connect the interface cables of the router.
•
Use an uninterrupted power supply (UPS).
•
Do not work alone when the router has power.
•
Always make sure the power has been disconnected during the installation and replacement
procedures.

Examining the installation site

The router can only be used indoors. To make sure the router operates correctly and to prolong its
service lifetime, the installation site must meet the following requirements.
Product code
RT-MSR830-6EI-GL
RT-MSR830-6HI-GL
RT-MSR830-10HI-GL
RT-MSR830-10EI-GL
1