Connecting An Ec Power Tool And An External Control (E.g. Se 200) - Bosch Rexroth LTH Technical Information Manual

42/60 Bosch Rexroth AG
2 Power Unit LTH

2.6.1 Connecting an EC power tool and an external control (e.g. SE 200)

The cable set from the manufacturer must be used to connect an external control to power unit LTH. The
units are connected according to fig. 5.
The control is connected via the IEC receptacle of the power unit to the power line.
WARNING: The safety measure "isolation by transformer" is used by power unit LTH. Therefore,
SE 200
X1 X2 X7
Fig. 5: Connecting an EC power tool and an external control
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
| Electric Drives and Controls
only power tool components and cables intended or authorized by the manufacturer
must be connected (see chapter 3 "Overview of Order Numbers for Smart Tools").
X8
Power supply
Netz X3
LTH | 3 609 929 408/2.1
LTH
0
X8 X7 X2 X1