Remote Access Code; Message Alert Tone - AT&T CL83519 User Manual

Answering system
Answering system settings

Remote access code

To access your answering system remotely from any touch-tone phone, you
need to enter a two-digit number (00-99). By default, the remote access code is
19.
To change the remote access code:
Using a cordless handset or the telephone base:
1. When the handset or telephone base is in idle mode, press MENU/
enter the main menu.
2. Press or
CID
3. Press or
CID
4. Press or
CID
5. Use the dialing keys to enter a two-digit number. Press
handset or
MUTE
digit.
6. Press /SELECT to save the setting.
MENU

Message alert tone

When the message alert tone is set to On, and there is at least one new
message, the telephone base beeps every ten seconds. By default, the message
There is no audible alert at the handset.
To change the setting:
Using a cordless handset or the telephone base:
1. When the handset or telephone base is in idle mode, press MENU/
the main menu.
2. Press or
CID
3. Press or
CID
4. Press or
CID
5. Press or
CID
6. Press /SELECT to save the setting.
MENU
to scroll to Answering sys, then press
DIR
to scroll to Ans sys setup, then press
DIR
to scroll to Remote code, then press
DIR
/DELETE on the telephone base to backspace and delete a
to scroll to Answering sys, then press
DIR
to scroll to Ans sys setup, then press
DIR
to scroll to Msg alert tone, then press
DIR
to choose On or Off.
DIR
86
SELECT
/SELECT.
MENU
/SELECT.
MENU
/SELECT.
MENU
/DELETE on the
MUTE
to enter
SELECT
/SELECT.
MENU
/SELECT.
MENU
/SELECT.
MENU
to