Table of Contents
Advertisement
USER TOOLS
Basic Settings
MENU
Auto Response
(Human) Sensor
Operation panel
beeper
Copy count display
Set date
Set time
Auto Reset
Low Power Timer
46
When the auto response sensor does not detect anyone
operating the machine for a while, it will switch to one of the
Reset modes (Auto Reset, Low Power mode, Auto Off, or
SADF Auto Reset). You change the delay before this cuts in.
Default: Yes (On)
The noise made when you push a button can be tumed off.
Default: On
The copy counter can be set to show the number of copies
made (count up) or the number of copies remaining to be made
(count down).
Default: Up (count up)
Use to set the date and copier's internal clock.
Date Stamping uses this date.
Remember to adjust the clock for Daylight Saving Time.
[
Next]
The machine returns to standby automatically a while after
every job. You can change the delay from 0 (no Auto Reset) to
180 seconds.
Default: 30 seconds
[U.S. model]
The copier will automatically enter a Low Power condition after
the selected time after the last copying job has been completed.
This time can be set from 1 to 120 minutes in 1 minute steps.
Default: 15 minutes
The operator can activate the Low Power mode by pressing the
Clear Modes/Low Power Mode key for more than one second.
Time required to return to a ready condition from the Low Power
mode is less than 30 seconds.
In this mode, power consumption is reduced from less than 0.20 kW
(standby) to less than 0.11 kW
[Europian model]
The copier will automatically enter a Low Power mode while
after the last job has been completed. You can change the
delay from 0 (Low Power mode off) to 180 seconds.
When "0" is set, the machine does not enter a Low Power mode.
DESCRIPTION
Advertisement
Table of Contents
