Call Transfer - Bang & Olufsen BeoCom 3 Manual

Use with a switchboard
The dialling code is normally automatically
added to incoming Caller ID calls with a
switchboard. However, some switchboards
may not add the code automatically. You
can therefore set BeoCom 3 to add a
dialling code.
Yes
No
Insert prefix for
Menu Press Menu to access the main
menu
Turn the wheel to find
OK 'Settings' and press OK
Turn the wheel to find
OK 'Advanced' and press OK
Turn the wheel to find
OK 'Switchboard' and press OK
Turn the wheel to select 'Yes'
OK or 'No' – press OK
0 – 9 If you select 'Yes', enter the
code using the numerical keys
– or use the wheel to edit the
code
OK Press OK to store the setting
When you store external names and numbers
in the Phonebook, you must first remember to
enter the dialling code and then the phone
number.

Call transfer

Beocom 3 is preset to the most commonly
used type of transferring external calls. If
your telephone is connected to a
switchboard, you may need to change this
setting in order to use this function.
Switchboard
public line
Menu
OK
OK
OK
OK
Call transfer
Normal
Switchboard
Use normal ISDN
signalling (ECT)
Press Menu to access the main
menu
Turn the wheel to find 'Setup
menu' and press OK
Turn the wheel to find
'Advanced menu' and press
OK
Turn the wheel to find 'Call
transfer' and press OK
Turn the wheel to select
'Normal' or 'Switchboard'
Press OK to save the setting
Reading the version number in
the phone display
If you need to give someone information
about the phone, perhaps because it is
being repaired, you can find this
information in the menu.
Version number
Country
SW version
HW version
Serial no.
Menu Press Menu to access the main
menu
Turn the wheel to find
OK 'Settings' and press OK
Turn the wheel to find
OK 'Advanced menu' and press
OK
Turn the wheel to find
OK 'Version number' and press OK
29
: UK
: x.x
: x
: xxxxxxxx