Installation - Kohler Englefield K-5627X Installation And Care Manual

Installation

Select a suitable position in the bathroom.
¨
Remove the screw at the bottom of the unit.
¨
Remove the front cover from the bottom
¨
and then lift up the front cover.
Mark 3 mounting holes of the heater base on
¨
the wall. The heater position should be 1.5 m
above the bathroom floor.
Drill 1 hole (upper part of heater base) with
¨
6 mm drill and make the anchor holes
Ø
in depth of 34 mm.
Rehearse heater unit installation for anchor
¨
mounting location determination.
Drill 2 holes (lower part of heater base)
¨
with 6 mm drill and make the anchor holes in depth of 34 mm.
Ø
For K-5627X:
¨
wall. It is recommended that the top of the portion is in level with the top of
heater.
For K-72989X
the wall.
K-72989X: K-72989X:
Bracket
Screw
Drill 2 holes
¨
with 6 mm drill
Ø
and make the
anchor holes
in depth of 34 mm.
Insert the anchors
¨
and mount the heater
firmly in position with
the screws provided.
Insert the shower holder and
¨
soap tray into the slider rail.
Mount the slider rail to the rail bracket.
¨
Remove the cap from the rail bracket and screw the bracket to marked
¨
position. Replace the cap.
1237889-X2-G
Mark 2 mounting holes of the slider rail beside the heater on the
: Mark 2 mounting holes of the brackets beside the heater on
Install with Bracket
Anchor
Adjustable
Shower Holder
K-5627X: K-5627X:
Install with Slider Rail
Cap
Screw
Rail
Bracket
Slider Rail
Flexible Angle
Adjustment
Soap
Tray
10
Anchor
4 Spray
Patterns
Selection
Handshower
Flow
Regulator
Rubber
Washer
Flexible Hose
Kohler Co.