Table of Contents
Advertisement
Installer Manual Fleck 5812 - XTR - Maintenance
9.4.6. Injector cleaning
No.
A
Remove the injector block clip (1) using a flat screwdriver on the dedicated slot (2).
B
Remove the injector cap (7) using a flat screwdriver on the dedicated slot (8).
C
Using the injector block clip (1), remove the injector (4).
Caution
To avoid any damage on the injector, use only the clip to remove it.
D
Remove the screen (5) using pliers.
E
Using the injector block clip (1), remove the injector plug (3).
F
Clean or change the injector (4), the screen (5), the injector plug (3) and the seal (6).
G
Lubricate all seals with approved silicone lubricant only.
H
Reverse above procedure steps to rebuild.
112 / 132
Operation
Ref. MKT-IM-019 / E - 14.10.2019
Advertisement
Table of Contents
