Connecting The Water Line - Oasis Quasar PWEBQ Installation Instructions Manual

Section 3B: Installation
B: Connecting the water line
Note: If you are retrofitting the Bottle Filler to an existing
cooler, follow the instructions starting on page 11.
For the single "Bottle Filler ready" cooler, the tube to connect to the Bottle
Filler is found inside the access panel (the compressor compartment). This
tube supplies cold water from the cooling tank to the Bottle Filler.
¼" OD tube to connect
to Versafiller
For split level "Bottle Filler ready" coolers, the tube to plumb in the Bottle
Filler is packaged in the dummy unit.
Remove tube from bag.
First, remove plug from
fitting on tank drain
Next, insert end of
tube into fitting.
9