Related Manuals for Oasis Waterways Estetica SAET310BLES
Summary of Contents for Oasis Waterways Estetica SAET310BLES
- Page 1 Bottom Load Tri-Temperature Estetica Water Cooler Please read user manual carefully before operating your water dispenser. Retain for future use.
- Page 2 Directory Safety Precautions Parts Diagram Specifications Setup Dispensing Water Replacing Bottle Cleaning & Maintenance Troubleshooting Warranty...
-
Page 3: Safety Precautions
Safety Precautions Warning: To reduce the risk of injury and property damage, user must read the entire guide before assembling, installing and operating dispenser. Failure to execute the instructions in this manual can cause personal injury or property damage. This product dispenses hot water above 176°F. Failure to use properly can cause personal injury. -
Page 4: Component Diagram
Component Diagram Rear Front Room Temp Button Cold Button Hot Button Indicators Night Night Light Water Outlet Light Switch Fuse Hot Tank Switch Drip Tray Dip Tube Power Cord Connector Hot Tank Drain Dip Tube Door Condenser... -
Page 5: Specifications
Cooler Information Indicators The Dispenser has 4 symbols on the front panel: This symbol indicates that there is power to the unit when illuminated. This symbol indicates that the hot tank is heating when illuminated. This symbol indicates that the unit is cooling when illuminated. When flashing this indicates that the bottle is empty. -
Page 6: Dispensing Water
Turning the Cooler On Note: Ensure cold water reservoir and hot tank have been filled with water prior to turning on hot tank switch as an empty tank can cause the dispenser to overheat. Turning On the Hot Tank • Push the red, hot tank switch (located on the rear of the cooler) to the “On”... -
Page 7: Cleaning And Maintenance
Cleaning & Maintenance For maximum efficiency and performance this water dispenser requires cleaning on a regular basis. Regular cleaning will help to maintain a clean and sanitary environment within the cooler. Only use food quality cleaners. • There is no maintenance required on the plastic cabinetry. Regular cleaning with hot water and a mild dish detergent is all that is required. -
Page 8: Troubleshooting
Troubleshooting Problem Possible Cause Suggestion Cold water is not cold Too much cold water usage Wait 45 min for water to cool. Inadequate ventilation Allow 8 inches clearance/side. Cold control turned up Adjust control fully clockwise. Fuse has blown Check fuse and replace. Dispenser is noisy Unit is not level Place on flat stable surface. - Page 9 Coverage is limited to replacing a defective cooler with a similar cooler, reimbursing the original purchaser from OASIS International for the amount paid for the defective cooler or providing parts to repair or replace any part of the water dispenser which is expressly covered by this Limited Warranty at the manufacturer’s option.