Table of Contents
Advertisement
Correctly closing the terminal box
2,37 Nm
44
ATTENTION
1. Before screwing on the cover, check all the seals and
surfaces are clean and positioned correctly.
2. Fit the cover (1) and then slide it upwards (2). Do not tilt
the cover.
3. Tighten the screws by hand at first and then use a torque
wrench to tighten them crosswise with a torque of 2.37
Nm.
Quick installation guide for solar inverter M88H RPI883M121300 RPI883M122300 EU V1 EN 5017414200_00 2019-11-07
Impairment of operating response caused by
moisture and dirt.
In order to restore degree of protection IP65
after the completion of installation work,
attach the cover of the wiring box in accordance
with the following instructions.
Advertisement
Table of Contents
