Connections - VCS VideoJet 1000 Manual

Connections

Camera
Monitor
Network
Alarm input
VideoJet 1000
Any standard video source (CCTV camera) can be connected to
the VideoJet 1000. All cameras and any video source which deli-
vers a standard PAL or NTSC signal are suitable.
Connect the camera or other video source using video cable
(75 Ohm, BNC connector) to the BNC socket Video In.
The VideoJet 1000 has an analog monitor output for connection to
a suitable PAL or NTSC monitor when the unit is to be used as a
receiver.
Connect the video monitor using video cable (75 Ohm, BNC con-
nector) to the BNC socket Video Out.
The VideoJet 1000 can be connected to a 10/100 Base-T network
either directly or via a hub. For this purpose use standard UTP
Cat 5 cable with RJ45 connectors.
Connect the network cable to the socket Ethernet.
The alarm input is provided for switching an external alarm gener-
ator, e.g. a door contact or sensor. Using the appropriate configura-
tion an alarm generator, for example, can activate the automatic
connection setup between the VideoJet 1000 and a remote loca-
tion.
A voltage free closing contact or switch can be used as activator.
Note
Where possible, a switch with minimum contact bounce should be
used as activator.
Installation
23