Dell EMC Inspiron 3671 Service Manual page 60

General
64-Bit Technology
Device Information
SATA-0
SATA-1
SATA-2
SATA-3
M.2 PCIe SSD-0
LOM MAC Address
Video Controller
Audio Controller
Wi-Fi Device
Bluetooth Device
Boot Sequence
Boot Sequence
Boot List Option
Advanced Boot Options
UEFI Boot Path Security
Date/Time
Table 4. System setup options—System Configuration menu
System Configuration
Integrated NIC
Enable UEFI Network Stack
60 System setup
Displays whether 64-bit technology is used.
Displays the SATA-0 device information of the computer.
Displays the SATA-1 device information of the computer.
Displays the SATA-2 device information of the computer.
Displays the SATA-3 device information of the computer.
Displays the M.2 PCIe SSD information of the computer.
Displays the LAN On Motherboard (LOM) MAC address of the computer.
Displays the video controller type of the computer.
Displays the audio controller information of the computer.
Displays the wireless device information of the computer.
Displays the Bluetooth device information of the computer.
Displays the boot sequence.
Allows you to change the order in which the computer attempts to find an operating system. The
options are:
• Windows Boot Manager
• Onboard NIC(IPV4)
• Oboard NIC(IPV6)
By default, all the check boxes are selected. You can clear the check boxes or change the boot order.
Displays the available boot options.
Allows you to change the boot list option:
• Legacy External Devices
• UEFI (default)
You can also add or delete a boot option.
Enable or disable legacy boot options when in UEFI boot mode.
• Enable Legacy Option ROMs (default)
• Enable Attempt Legacy Boot
These options control whether the computer will prompt the user to enter the Admin password (if
set) when booting a UEFI boot path from the F12 Boot Menu .
• Always Except Internal HDD (default)
• Always, Except Internal HDD&PXE
• Always
• Never
Displays the current date in MM/DD/YY format and current time in HH:MM:SS AM/PM format.
Controls the on-board LAN controller.
Allows you to configure the integrated network controller. The options are:
• Disabled
• Enabled
• Enabled w/PXE (default)