EarthWay 2040Pi-Plus Assembly And Operating Instructions

2040Pi-P
lus
ASSEMBLY and OPERATING INSTRUCTIONS
Congratulations on the purchase of this new HIGH-OUTPUT spreader. Please call us if you have any difficulty with assembly
or operation of this spreader. We can be reached via the telephone at 800-294-0671 or 574-848-7491 Monday—Friday
9:00am ~ 4:00pm or visit us online at www.earthway.com This spreader comes with lifetime technical support, email us at
support@earthway.com if you have any questions.
HELPFUL HINTS: READ THE DIRECTIONS BEFORE ASSEMBLY
THIS SPREADER COMES PARTIALLY ASSEMBLED, REQUIRING YOU TO INSTALL THE CONTROL ROD AND WILL
REQUIRE 1 PAIR OF PLIERS.
5 Your spreader is designed to be pushed at three miles per hour, which is a brisk walking speed. Slower or faster speeds will change
the spread patterns.
5 Prior to your first use, coat all metal parts (inside and outside tubing) with WD-40 or other spray lube to help prevent corrosion.
5 Clean your spreader thoroughly after each use. Wash with clean water and dry thoroughly and spray a light coating of oil on all
metal parts (inside all of the tubing) to help prevent corrosion.
5 Gears are permanently lubricated at the factory. Do not open the gearbox or dirt may enter.
ASSEMBLY INSTRUCTIONS
STEP 1:
Remove spreader from carton and pull handle into
position shown at right. Tighten wingnuts to secure.
STEP 2:
Install Control Rod into
handle as shown above.
TIP: Install the Control Rod
using pliers to squeeze into
Lever.
STEP 3:
Rotate forward.
Assembly is complete. Set the stop on the Control
Assembly for the desired setting and your spreader
is ready to operate.
5-Year LIMITED WARRANTY
Earthway Products, Inc. warrants this product free of defects in original workmanship and materials for a period of 5-years to the end user
with the original purchase receipt for at home use. If used for business, the warranty is 90-days. If a manufacturing non-conformance
is found, Earthway Products, Inc. at its discretion will repair or replace the part(s) or product at no charge provided the failure is not the
result of incorrect installation, mishandling, misuse, tampering, or normal wear and tear as determined by Earthway. Earthway at its
discretion may require that the part(s) or product be returned along with the original purchase receipt at owners' expense for examination
and compliance with the terms of this warranty. Do not return any product without first receiving authorization from Earthway Products,
Inc. To seek remedy under this warranty, contact Earthway Products, Inc. at 574-848-7491, support@earthway.com or write to Earthway
Products, Inc. P.O. Box 547 Bristol, Indiana 46507 and describe the nature of the manufacturing defect. SPECIFIC LIMITATIONS: This
warranty covers only the part(s) or product; any labor charges associated with repair or replacement of non-conformances are specifically
excluded. Due to the corrosive nature of most fertilizers and ice melt products, Earthway Products, Inc. makes no warranty against and
specifically excludes part(s) or product degradation or failure due to corrosion or its effects. Clean and dry your spreader thoroughly after
each use, as a preventative measure, coat all metal parts with a light oil or silicon spray.
HIGH-OUTPUT
STEP 4:
Insert Control
Rod into Pivot
and secure with
Hair Pin Clip.
Earth Way
Earth Way
 
11-2018 Pt. #52214PIR
R
R