EarthWay HIGH-OUTPUT 2040Pi-Plus Assembly And Operating Instructions

2040Pi-P
lus
ASSEMBLY and OPERATING INSTRUCTIONS
Congratulations on the purchase of this new EarthWay spreader. Please call us if you have any difficulty with assembly
or operation of this spreader. We can be reached via the telephone at 800-294-0671 or 574-848-7491 Monday—Friday
9:00am ~ 4:00pm or visit us online at www.earthway.com This spreader comes with lifetime technical support, email us at
techsupport@earthway.com if you have any questions.
HELPFUL HINTS: READ THE DIRECTIONS BEFORE ASSEMBLY
THIS SPREADER COMES PARTIALLY ASSEMBLED, REQUIRING YOU TO INSTALL THE CONTROL ROD AND WILL
REQUIRE 1 PAIR OF PLIERS.
5 Your spreader is designed to be pushed at three miles per hour, which is a brisk walking speed. Slower or faster speeds will change
the spread patterns.
5 Prior to your first use, coat all metal parts (inside and outside) with WD-40 or other spray lube to help prevent corrosion.
5 Clean your spreader thoroughly after each use. Wash with clean water and dry thoroughly and spray a light coating of oil to help
prevent corrosion.
5 Gears are permanently lubricated at the factory. Do not open the gearbox or dirt may enter.
ASSEMBLY INSTRUCTIONS
STEP 1:
Remove spreader from carton and pull handle into
position shown at right. Tighten wingnuts to secure.
STEP 2:
Install Control Rod into
handle as shown above.
STEP 3:
Rotate forward.
Assembly is complete. Set the stop on the Control
Assembly for the desired setting and your spreader
is ready to operate.
5-Year LIMITED WARRANTY
EarthWay Products, Inc. warrants this product free of defects in original workmanship and materials for a period of 5-years to the end user
with the original purchase receipt. If a manufacturing non-conformance is found, EarthWay Products, Inc. at its discretion will repair or
replace the part(s) or product at no charge provided the failure is not the result of incorrect installation, mishandling, misuse, tampering,
or normal wear and tear as determined by EarthWay. EarthWay at its discretion may require that the part(s) or product be returned along
with the original purchase receipt at owners' expense for examination and compliance with the terms of this warranty. (Do not return
any product without first receiving authorization from EarthWay Products, Inc.). To seek remedy under this warranty, contact EarthWay
Products, Inc. at 574-848-7491, techsupport@earthway.com or write to (EarthWay Products, Inc. P.O. Box 547 Bristol, Indiana 46507) and
describe the nature of the manufacturing defect. SPECIFIC LIMITATIONS: This warranty covers only the part(s) or product; any labor
charges associated with repair or replacement of non-conformances are specifically excluded. Due to the corrosive nature of most fertilizers
and ice melt products, EarthWay Products, Inc. makes no warranty against and specifically excludes part(s) or product degradation or failure
due to corrosion or its effects. Clean and dry your spreader thoroughly after each use, as a preventative measure, coat all metal parts with a
light oil or silicon spray.
HIGH-OUTPUT
STEP 4:
Insert Control
Rod into Pivot
and secure with
Hair Pin Clip.
Part #52214PIR