Using Show Commands To Verify The New Interface Status - Cisco PA-E3 Series Installation And Configuration Manual

Chapter 4 Configuring the PA-E3

Using show Commands to Verify the New Interface Status

Table 4-5
and operating correctly and that the PA-E3 appears in them correctly. Sample displays of the output of
selected show commands appear in the sections that follow. For complete command descriptions and
examples, refer to the publications listed in the
The outputs that appear in this document may not match the output you receive when running these
Note
commands. The outputs in this document are examples only.
Table 4-5 Using Show Commands
Command
show version or
show hardware
show controllers
show diag slot
The slot argument is not required
Note
with Catalyst 5000 family switches.
show interfaces type 0 or 1/
interface-port-number
show interfaces type module-slot-
number/port-adapter-bay-number/
interface-port-number
show interfaces type
3/interface-port-number
show interfaces type
4/interface-port-number
OL-3502-04
demonstrates how you can use the show commands to verify that new interfaces are configured
Function
Displays system hardware
configuration, the number of
each interface type installed,
Cisco IOS software version,
names and sources of
configuration files, and boot
images
Displays all the current interface
processors and their interfaces
Displays types of port adapters
installed in your system and
information about a specific
port adapter slot, interface
processor slot, or chassis slot
Displays status information
about a specific type of interface
(for example, serial) on a
Catalyst RSM/VIP2
Displays status information
about a specific type of interface
(for example, serial) on a
Catalyst 6000 family FlexWAN
module
Displays status information
about a specific type of interface
(for example, serial) in a Cisco
7120 series router
Displays status information
about a specific type of interface
(for example, serial) in a Cisco
7140 series router
"Related Documentation" section on page
Example
Router# show version
Router# show controllers
Router# show diag 2
Router# show interfaces serial 1/0
Router# show interfaces serial 3/0/0
Router# show interfaces serial 3/1
Router# show interfaces serial 4/1
PA-E3 Serial Port Adapter Installation and Configuration
Checking the Configuration
viii.
4-13