Using Show Commands To Verify The New Interface Status - Cisco PA-2FE-TX Installation And Configuration Manual

Chapter 4 Configuring the PA-2FE

Using show Commands to Verify the New Interface Status

Table 4-4
and operating correctly and that the PA-2FE appears in them correctly. Sample displays of the output of
selected show commands appear in the sections that follow. For complete command descriptions and
examples, refer to the publications listed in the
The outputs that appear in this document may not match the output you receive when running these
Note
commands. The outputs in this document are examples only.
Table 4-4 Using show Commands
Command
show version or
show hardware
show controllers
show diag slot
show interfaces type 3/interface-port-
number
show interfaces type 4/interface-port-
number
show interfaces type
slot-number/interface-port-number
Note For the Cisco 7206 router
shelves, the show interfaces
command requires a shelf
number in the format show
interfaces type shelf
number/port adapter slot/port.
show interfaces type
interface-processor-
slot-number/port-adapter-slot-number/
interface-port-number
OL-3474-06
demonstrates how you can use the show commands to verify that new interfaces are configured
Function
Displays system hardware
configuration, the number of each
interface type installed, Cisco IOS
software version, names and
sources of configuration files, and
boot images
Displays all the current interface
processors and their interfaces
Displays types of port adapters
installed in your system and
information about a specific
port adapter slot, interface
processor slot, or chassis slot
Displays status information about a
specific type of interface (for
example, fastethernet) in a
Cisco 7120 series router
Displays status information about a
specific type of interface (for
example, fastethernet) in a
Cisco 7140 series router
Displays status information about a
specific type of interface (for
example, fastethernet) on a
Cisco 7200 series router,
Cisco uBR7200 series routers,
Cisco 7301 router, or
Cisco 7401ASR router
Displays status information about a
specific type of interface (for
example, fastethernet) on a VIP in a
Cisco 7500 series router
PA-2FE-TX and PA-2FE-FX Two-Port Fast Ethernet Port Adapter Installation and Configuration
"Related Documentation" section on page
Example
Router# show version
Router# show controllers
Router# show diag 2
Router# show interfaces fastethernet 3/1
Router# show interfaces fastethernet 4/1
Router# show interfaces fastethernet 1/0
Router# show interfaces fastethernet
3/1/0
Checking the Configuration
viii.
4-9