Cisco 7201 Router-Example Output Of The Show Interfaces Command; Cisco 7401Asr Router-Example Output Of The Show Interfaces Command - Cisco PA-4E1G Series Installation And Configuration Manual

Serial port adapter
Table of Contents

Advertisement

Checking the Configuration
Output queue: 0/64/0 (size/threshold/drops)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
Cisco 7201 Router—Example Output of the show interfaces Command
Following is an example of the show interfaces command for a Cisco 7201 router:
Router# show interfaces
GigabitEthernet0/0 is up, line protocol is up
Hardware is MV64460 Internal MAC, address is 0019.56c5.2adb (bia
0019.56c5.2adb)
Internet address is 209.165.200.225
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 1000Mb/s, media type is RJ45
output flow-control is XON, input flow-control is XON
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:07:03, output 00:00:07, output hang never
Last clearing of "show interface" counters 00:00:04
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 180240000 bits/sec, 430965 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
Cisco 7401ASR Router—Example Output of the show interfaces Command
Following is an example of the show interfaces serial command for a Cisco 7401ASR router. This
example shows all of the information specific to interface port 0 on a PA-4E1G installed in port adapter
slot 1:
Router# show interfaces serial 1/0
Serial1/0 is up, line protocol is up
Hardware is 4ME1-UNBAL
Internet address is 5.0.0.2/8
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, rely 255/255, load 1/255
Encapsulation HDLC, loopback not set, keepalive not set
PA-4E1G Serial Port Adapter Installation and Configuration
4-22
Conversations
0/0 (active/max active)
Reserved Conversations 0/0 (allocated/max allocated)
33 packets input, 10824 bytes, 0 no buffer
Received 66 broadcasts, 0 runts, 0 giants
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
0 alarm indications, 0 remote alarms, 0 rx LOF, 0 rx LOS
DCD up, BER inactive, NELR inactive, FELR inactive
reliability 255/255, txload 1/255, rxload 45/255
2222975 packets input, 133378500 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
0 input packets with dribble condition detected
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 pause output
0 output buffer failures, 0 output buffers swapped out
Chapter 4
Configuring the PA-4E1G
OL-3065-05

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pa-4e1g-75Pa-4e1g-120

Table of Contents