Table of Contents
Advertisement
Port Adapter Removal and Installation
Cisco 7201 Router—Removing and Installing a Port Adapter
Step 1
Use an ESD wrist strap to ground yourself to the router.
Step 2
To remove the port adapter, place the port adapter lever in the unlocked position. The port adapter lever
remains in the unlocked position.
Step 3
Grasp the handle of the port adapter and pull the port adapter about halfway out of its slot. If you are
removing a blank port adapter, pull the blank port adapter completely out of the chassis slot.
Step 4
With the port adapter halfway out of the slot, disconnect all cables from the port adapter.
After disconnecting the cables, pull the port adapter from the chassis slot.
Caution
The port adapter must slide into the slot guides close to the chassis lid. Do not allow the port adapter
components to come in contact with the system board or the port adapter could be damaged.
Step 5
To insert the port adapter, carefully align the port adapter carrier in the slot guides. Slide the new port
adapter halfway into the chassis.
Step 6
Connect all the required cables to the port adapter. After connecting all required cables, carefully slide the
port adapter all the way into the slot until the port adapter is seated in the midplane.
Step 7
After the port adapter is properly seated, lock the port adapter lever.
PA-MC-T3 Port Adapter Installation and Configuration
3-10
SLOT 1
GIGA BIT ETHE
RNET 0/0
RJ45 EN
GIGA BIT ETHE
LINK
RNET 0/1
RJ45 EN
TX
GBIC
Cis co 72
RX
LINK
01
TX
GBIC
RJ45 EN
LINK/ ACTV
ATM
SFP
RJ45
EN
LINK/ ACTV
TX
SFP
CIS CO 730
1
GE 0/0
GE 0/1
Chapter 3
GIGA BIT ETHE
RNET 0/2
RJ45 EN
RX
LINK
AUX
CONS OLE
CONS OLE
TX
GBIC
RX
LINK/ ACTV
RX
100-2 40V,
SFP
LINK/ ACTV
2A, 50/60
24V= 9A,
Hz
TX
48 - 60V=
SFP
ALAR M
5A
RX
MNGM NT
USE ONLY
COMP ACT
FLAS H
STATU S
GE 0/2
ALAR M
GE 0/3
AUX
PWR OK
FE 0/0
0
FE
LINK
COM PAC T
STAT US
FLA SH
CF
ACTV
Removing and Installing Port Adapters
OL-2695-05
Advertisement
Table of Contents
