Philips FC8820 Manual page 25

Problem Cause
The suction opening in the
bottom of the dust container
is clogged.
The front wheel is jammed
with hair or other dirt.
The battery can The rechargeable battery has
no longer be reached the end of its life.
charged or runs
empty very fast.
The battery of the Perhaps you did not insert the
remote control correct type of battery.
runs empty too
fast.
Error code Possible cause
E1 Wheels stuck
E2 Top cover or dust
container not
placed properly
E3 Bumper stuck
E4 Robot lifted up
from floor
E5 Colour of floor
too dark
E6 Battery not
inserted properly
Charging error
Error codes
Solution
Remove the robot from the obstacle and press the on/off
button to resume cleaning.
Place the dust container in and the top cover on the
robot properly. The error code disappears from the display
automatically.
Remove the robot from the obstacle. The error code
disappears from the display automatically.
Put the robot back on the floor to make the error code
disappear.
Place the robot on a lighter area of the floor. Clean the
drop-off sensors.
Read the instructions in 'Inserting the rechargeable battery
into the robot' in chapter 'Before first use'.
Check if the power switch is in 'on' position when the robot
is on the docking station.
Solution
If brushing does not help to clean the filter,
replace the filter with a new one (see chapter
Replacement').
Clean the suction opening (see chapter 'Cleaning
and maintenance').
Clean the front wheel (see chapter 'Cleaning and
maintenance').
Replace the rechargeable battery (see chapter
'Replacement').
For the remote control, you need a CR2025
coin-shaped battery. If the problem persists,
go to www.philips.com/support or contact the
Consumer Care Centre in your country.
ENGLISH
25