Philips FC8820 Manual page 21

6 Put the dust container back into the dust container compartment
and put the top cover back onto the robot.
Caution: Always make sure the filter is present inside the dust container.
If you use the robot without the filter inside the dust container, the motor
will be damaged.
Cleaning sensors, wheels and side brushes
To maintain good cleaning performance, you have to clean the drop-off
sensors, the wheels and the side brushes from time to time.
1 Make sure the power switch is in 'off' position.
2 Place the robot upside down on a flat surface.
3 Use a brush with soft bristles (e.g. a toothbrush) to remove dust or
fluff from the drop-off sensors. Also check if there is any dirt or fluff
blocking the suction opening.
Note: It is important that you clean the drop-off sensors regularly. If the drop-
off sensors are dirty, the robot may fail to detect height differences.
4 Use a brush with soft bristles (e.g. a toothbrush) to remove dust or
fluff from the front wheel and side wheels.
5 To clean the side brushes, grab them by the bristles and pull them off
their shafts.
6 Remove fluff, hairs and threads from the shaft and from the side
brush with a soft brush (e.g. a toothbrush) or a cloth.
7 Check the side brushes and the bottom of the robot for any sharp
objects that could damage your floor.
ENGLISH
21