DISASSEMBLY- AND RE-ASSEMBLY ADVISE FC8820/01 • First make sure that the appliance is unplugged. • Turn the appliance upside down . • To empty and/or replace the Dustbin assy, the Top Cover • The brushes can easily be pulled out and replaced, after has to be removed (see picture).
Page 3
REPAIR INSTRUCTION FC8820/01 IR Sensors calibration for replacing PCBA After calibration the robot need to be tested for the drop- down sensors: This can be done on a table. If the robot Purpose: IR Sensors have to be calibrated if replacing does not fall from the table the calibration was done in a PCBA.
Page 4
REPAIR INSTRUCTION FC8820/01 Wiring diagarm Battery socket, Left brush, Left wheel, Red, black Green Black and and brown and blue brown Bumper PCB, Rear IR, Right brush, Right wheel, Black, brown, red, Purple Blue and Orange orange and green and black black and black Front IR...
REPAIR INSTRUCTION FC8820/01 Troubleshooting: Problem Cause Solution 1. The robot does not charge. a. Power Switch is off . • When charging the robot the Power switch should be "on", otherwise the robot will not be charged. 2. The robot does not charge, a.
Page 6
REPAIR INSTRUCTION FC8820/01 Problem Cause Solution 8. The robot does not clean and a. The dust container is not • Place the dust container in the dust container warning indicator lights up present. compartment properly. Make sure you close continuously. the dust container cover properly.
PARTS LIST FC8820/01 Service code Description Remark 4322 006 67931 Suction motor assy D 4322 006 22931 Recharable battery 2800 mAh - 14.8 V Li-Ion 4322 006 09981 Switching adaptor 30 V - 1000 mA Euro plug 4322 006 23131 Docking station C 4322 006 21331 Remote control B...
Page 17
FC8820/01 Version history 15/03 Version 1.1 : FC8820/01 initial release. 15/07 Version 1.2 : In Parts List at Pos. 14, changed 4322 004 94171 into 4322 004 94172. 15/10 Version 1.3 : In Parts List at Pos. 21, changed 9965 100 72845 into 4322 006 25881. Added on page 3: IR Sensors calibration for replacing PCBA.