Table of Contents
Advertisement
Problem
Possible solution
Mower doesn't run when
Check to make sure mower is properly plugged
bail handle is activated.
in and that the button on switch box is being
completely depressed before pulling the bail
handle.
Release bail handle to turn mower off. Remove
safety key and battery pack, turn mower over
and check that blade is free to turn.
Check that the battery cavity is free of debris
and is connected properly.
Has battery been fully charged? Press state of
charge button.
Motor stops while mowing.
Release bail handle to turn mower off. Remove
safety key and battery pack Turn mower over
and check that blade is free to turn.
Raise cutting height of wheels to highest posi-
tion and start mower.
Check that the battery cavity is free of debris
and is connected properly
Has battery been fully charged? Press state of
charge button
Avoid overloading the mower. Slow down the
cutting pace, or raise the cut height.
Mower runs but cutting
Release bail handle to turn mower off. Unplug
performance is unsatisfac-
mower. Turn mower over and check:
tory,
u
u
Wheel height adjustment may be set too low for
grass condition. Raise cutting height.
Mower is too hard to push.
Release bail handle to turn mower off. Unplug
mower. Raise cutting height to reduce deck
drag on grass. Check each wheel for free
rotation
Mower is abnormally noisy
Release bail handle to turn mower off.
and vibrates.
Unplug mower. Turn mower on side and
check blade to ensure it has not been bent or
damaged. If blade is damaged, replace with
a BLACK+DECKER replacement blade. If
the underside of the deck is damaged, return
mower to a BLACK+DECKER Authorized
service center.
If there is no visible damage to the blade and
the mower still vibrates:
u
u
u
u
u
If mower still vibrates, return the mower to
an authorized BLACK+DECKER authorized
service center.
Battery charger LEDs
Check plug connection.
not on.
Replace charger.
Mower not picking up
Chute clogged. Release bail handle to turn
clippings with bag.
mower off. Unplug mower. Clear chute of grass
clippings.
Raise cutting height of wheels to shorten length
of the cut.
Bag full. Empty bag more often.
Protecting the environment
Z
Separate collection. Products and batteries
marked with this symbol must not be disposed of
with normal household waste.
18
Blade for sharpness - Keep blade sharp.
Deck and discharge chute for clogging.
Release bail handle to turn mower off.
Unplug mower.
Disassemble entire blade assembly as
described in the "Removing and installing
blade" section.
Remove any debris and clean each piece.
Replace each piece as described in the
"Removing and installing blade" section.
Products and batteries contain materials that can be
recovered or recycled, reducing demand for raw materials.
Please recycle electrical products and batteries according to
local provisions. Further information is available at
www.2helpU.com
Technical data
Voltage
Vdc
-1
min
No-Load Speed
kg
Weight
Blade length
mm
Battery
V
Voltage
DC
Capacity
Ah
Type
Charger
V
Input Voltage
AC
Output Current
mA
Approx. charge
h
time
Hand/arm weighted vibration value:
= 4.4m/s
, uncertainty (K) = 1.5m/s
2
L
(sound preasure) 83 dB(A)
PA
uncertainty (K) = 2.5 dB(A)
EC declaration of conformity
%
MACHINERY DIRECTIVE
OUTDOOR NOISE DIRECTIVE
CLM5448PC, CLM544PCB lawn mower
Black & Decker declares that these products described under
"technical data" are in compliance with:
2006/42/EC, EN 60335-1:2012 + A11:2014,
EN 60335-2-77:2010
2000/14/EC, Lawn Mower, L < 50cm, Annex VI,
DEKRA Certification B.V., Utrechtseweg 310, ED Arnhem
Netherlands Notified Body ID No.: 0344
Level of accoustic power according to 2000/14/EC (Article 12,
Annex III, L< 50cm):
L
(measured sound power) 89.5 dB(A)
WA
uncertainty (K) = 1.2 dB(A)
L
(guaranteed sound power) 96 dB(A)
WA
CLM5448PC
CLM5448PCB
54V
0 - 2900
0 - 2900
26.62
48
Bare Unit. (No
BL2554
Battery supplied)
54/18v DUALVOLT
2.5
LI-Ion
Bare Unit. (No
BDC2A
Charger supplied)
220 - 240
2000mA
3.75
.
2
54V
24.15
48
Advertisement
Table of Contents
