Black+Decker CLM5448PC Original Instructions Manual page 15

Hide thumbs Also See for CLM5448PC:
Table of Contents

Advertisement

Bagging
Warning: remove key and battery packs before removing side
discharge attachment and Mulching insert, and when opening
rear door cover and Installing bag.
Ensure the side discharge attachment (26) (Figure M) and
u
the mulching insert (27) (Figure L) are removed from the
mower before bagging.
Lift the rear door cover (9) and place the grass collection
u
bag (8) onto the mower so the bag hooks (28) rest on the
lugs (29) as shown in Figure K. Then lower the rear door
cover.
Mulching
Warning! Remove key and Battery packs before removing
Side discharge attachment and Collection bag, and when
Installing mulching insert.
Ensure the side discharge attachment (26) and the
u
collection bag (8) are not attached.
Lift the rear door cover (9) and slide the mulching insert
u
(27) fully into the mower as shown in Figure L.
Ensure the rear door cover fully closes before turning
u
mower on.
Side discharge
Warning! Remove key and Battery packs before removing
Collection bag, and when Installing mulching insert and
Side discharge attachment.
Ensure the collection bag (8) is removed.
u
Lift the rear flap (9) and slide the mulching insert (27) fully
u
into the mower as shown in Figure L.
Lift the side flap (30) and hook side discharge attachment
u
(26) onto the mower as shown in Figure M.
Release the side flap and ensure the attachment holds in
u
place before turning mower on as shown in the insert of
Figure M.
Operation
Read this instruction manual before operating your mower.
See "Features" to familiarize yourself with the location of
various controls and adjustments. Save this manual for future
reference.
Warning! Let the mower work at its own pace. Do not
overload.
Warning! Sharp moving blade. Do not operate the mower in
side discharge or mulching mode if the rear door is not
closed under spring tension as serious injury could result.
Take your mower to the nearest service center for repair.
Adjusting handle height (fIg. N)
Open both lower-handle attachment levers (6).
u
Adjust the handle so the arrow (19) on the base of the
u
mower lines up with 1, or 2 on the base of the handle (20).
(Original instructions)
Ensure the handle is set to the same number on both
sides of the mower.
Close both levers and ensure the handle is firmly latched
u
and the teeth are engaged as shown in inset.
Adjusting mower height (fIg. O)
The height of cut is adjusted by the central cut height adjust
lever, there are 7 positions to choose from.
Note: If you are not sure which height to cut, begin mowing
with the height adjustment lever (7) in position 7 and adjust
the height down as needed, as shown in figure O.
To set the height of cut:
Pull the mower height adjustment lever (7) out of the
u
locking notch (31).
Move the lever towards the rear of the appliance to raise
u
the height of cut.
Move the lever towards the front of the appliance to lower
u
the height of cut.
Push the height adjustment lever into one of the seven
u
locking notches.
Safety key
In order to prevent accidental start-up or unauthorized use of
your Cordless Mower, a removable safety key (32) has been
incorporated into the design of your mower. The mower will be
completely disabled when the safety key has been removed
from the mower.
Note: The safety key has a Hole in the center to allow
for storage on a nail, out of The reach of children. Do not
tether safety key to mower.
Warning! rotating blades can cause serious injury.
To prevent serious injury, remove safety key when unattended,
or when charging, cleaning, servicing, transporting, lifting, or
storing mower.
Starting mower
Warning! Sharp moving blade. Never attempt to override the
operation of this switch box as serious injury could result.
Note: Mower is operational when battery and safety key are
installed.
Insert safety key (32) into the switch housing (1) until it is
u
fully seated inside housing as shown in Figure P. The
mower is now operational
Your mower is equipped with a special on-off switch box.
u
To operate the mower, push the button (33) on the switch
box (1), then pull the bail handle (2) to the handlebar
as shown in Figure Q. Once the mower starts you can
release the button.
To turn the mower off, just release the bail handle.
u
Warning! Never attempt to lock a switch or bail handle (2) in
the on position.
ENGLISH
15

Advertisement

Table of Contents
loading

This manual is also suitable for:

Clm5448pcb

Table of Contents