Advertisement
9. Attach the lower face to the fireplace by inserting the tabs on the bottom into the slots provided in the insert.
The face should be aligned flush with the insert. Tilt the front of the assembly up slightly as you guide it into
place.
Figure 17: Attaching the lower face
NOTE: If the power cord is routed on the hearth, make sure it is routed through the cut-away in the bottom of the
face.
Figure 19: Routing the power cord
10. Attach the air control rod extension to the air control rod on the unit.
Figure 21: Attaching the air control rod
Page 5 of 7
Large Flush Wood Hybrid-Fyre Insert:
Cypress Face Installation
17601689 - Printed 4/10/12
(96400539)
Figure 18: Face aligned flush with the insert
Figure 20: Routing the power cord
Figure 22: Tightening the air control rod
© Travis Industries, Inc.
Advertisement
