Advertisement
3. Remove the bypass rod from the fork in the insert, and set aside for later use.
4. Attach the face to the insert by inserting the tabs located on the face into the vertical slots located in the
1-piece panel.
5. On the left side, connect the Molex connector from the face to the Molex connector on the insert.
6. Tuck excess wires into the cavity near the blower. Make sure they do not contact hot (the bottom of the
firebox) or moving components.
Page 3 of 7
Large Flush Wood Hybrid-Fyre Insert:
Cypress Face Installation
Figure 9: Attaching the face
Figure 10: Connecting the Molex connectors
Figure 11: Tuck excess wires
17601689 - Printed 4/10/12
(96400539)
© Travis Industries, Inc.
Advertisement
