Large Flush Wood Hybrid-Fyre Insert:
Cypress Face Installation
(96400539)
7. Attach the shorter extension rod from this kit to the back of the existing air control rod assembly.
NOTE: If the power cord is routed onto the hearth, make sure to remove the tab on the face, as shown below
(either side may be used).
Figure 12: Cut‐away in face
Figure 13: Bending the tab on the face
Figure 14: Removing the cut‐away covering
8. Place the bottom section of the face near the insert. Connect the wires at the bottom left and right sides of the
face.
Figure 15: Connecting the bottom left wires
Figure 16: Connecting the bottom right wires
Page 4 of 7
17601689 - Printed 4/10/12
© Travis Industries, Inc.