Advertisement
Installation
1. Lay the face upside down on a non-scratching flat surface. Align the sides with the top of the face and secure
with the 4 nuts. Use a 3/8" wrench to tighten the nuts.
Figure 3: Nut location
2. Secure the wires to the face using lock-ties. Make sure the wires are secured at all 3 locations. Tighten the
lock-ties and cut off excess tie. Do not over-tighten.
Figure 5: Lock‐tie
Figure 7: Wires secured with lock‐tie
Page 2 of 7
Large Flush Wood Hybrid-Fyre Insert:
Cypress Face Installation
17601689 - Printed 4/10/12
(96400539)
Figure 4: Tightening a nut
Figure 6: Securing the lock‐tie
Figure 8: Wires routed
© Travis Industries, Inc.
Advertisement
